InterFace Sealing Solutions

Application Analysis Form

Home » Service and Support » Product Selection » Application Analysis Form

*First Name:
*Last Name:
*Company Name:
*Phone:	ext.
Fax:
*Email:

Option 1: Complete all the items listed below for a basic application analysis (GMX Flange Modeling). Information may be provided in either English or Metric units (please list units).

Option 2: For a more accurate analysis, provide CAD files (.dxf or .igs) of the flanges - then only the items in red are required. NOTE: Option 2 is required for applications above 60psi (4 bar).

Bolt Information: List up to three bold descriptions (include additional on a separate page).

	1	2	3
Size/Type (e.g. 3/8"-16, M8x1.25)
Quantity (of each type)
Thread Friction Factor (unknown=0.2)
Torque Range
Effective Grip Length (see diagram)
Body Length (see diagram)

GENERAL FLANGE INFORMATION

Gasket to Flange Contact Area

Flange Material (list modulus if other than Steel, Iron, or Aluminum)

Temperature Range (Continuous/Intermittent)

Surface Finish / Flatness Limits for Flanges

Compressed Thickness Requirements (if any - for tolerance stackups)

Other Loads/Moments acting on Gasket/Flange (describe)

BOLT SPAN INFORMATION: The most critical span should be analyzed. If a new application, consider centerline deviaton, flange thickness, etc. If you are evaluating a trouble area, then the bolt span where leakage occurs should be modeled.


Bolt Centerline Distance
Centerline Deviation (^)
Flange Thickness (at midspan)
Flange Width (at midspan)
Gasket Width (at midspan)
Bolt Type (from above)
Fluid Type
Fluid Pressure
Fluid Aperture Area
Fluid Flow Rate (if any)